Creating Dimensions!

There are many ways to create dimension, to a 2D looming pattern. One way is to add an outline, as I did here, for the basic design of my Lotus SLN. This gives depth without adding much more, but for me, it is adding an additional layer that I wanted to add.

It is accomplished much like you would complete 'bead embroidery', stringing three or four beads, taking a stitch then going back through the last two or three beads added. When I make my stitch, I am careful to only pick up either the warp or run my thread through a set of loomed beads. This way, I won't have any threads showing on the underside of my looming when finished, nor will I have to back my design.

To create the next level of dimension, I thread a 6mm Permanent Silver Metallic bead onto the thread, securing this bead in between the level I am adding and the base below. You can notice a few of these large beads, placed in between my petals. Some areas, I chose to add two instead of just one.

If you are familiar with 'Paper Tole', the art of cutting out the same design and reassembling the picture using silicone glue to make the picture look 3D. I call my method of creating dimension on this SLN, 'Bead Tole'.

Looking from different vantage points, you can see the dimensions come to life. I am even including some 'cupped' petals which will also create a realistic feel, as in the petal on the lower right side.

From the front view, you don't notice the levels of dimension, but after adding more, you will be able to notice this picture from any angle.

There is many more parts to chart/graph and hand weave, which will finally bring me to my total picture. I have attached all that I have completed, to this point, and will be graphing out other portions to hand weave. The green leaves, in the lower part of the Lotus, will be some of the last parts added, as they stand further forefront.